Bigaimaj Floor Covering Foil Self-Adhesive Laminated Stone Pattern 60 cm X 100 cm

Our product measurement: width: 60 cm, length: 100 cm (please pay attention to the dimensions when purchasing.) after determining your floor size, choose how many prints you will take. for example; if your floor is 240cm x 200cm, your order quantity should be 8 pieces. (2.40 x 2 = 4.80. the square meter of the product is 0.60 m. 4.80 / 0.60 = 8 pieces.) please write a message about the width and length of the area you will apply to us.

There may be a 5-10% tone difference in the products. our floor covering foil is coated with special lamination. it does not require glue, it is self-adhesive. it is not paper and is not affected by water. you can easily apply it yourself. you too; you can renew your floor without breaking it, without spilling it, without any renovation trouble! our products are printed with harmless latex technology. it is shipped as a whole, you can cut it to the sizes you want and use it. it is suitable for all flat and smooth surfaces. it is resistant to water, humidity and liquid surface cleaners. you can easily use chemicals such as bleach. it can be easily used in areas with few items such as kitchen, bathroom, corridor. items should not be pulled on furnished areas. you can attach felt to the feet.

APPLICATION:

We need to make sure the floor you're applying the foil covering to is flat and smooth. If the area we are going to cover is a rough and coarse area, the adhesive foil will not stick to this area. Firstly, to achieve a perfect result, the area to be coated should be free from dust, dirt, oil, silicone, etc. We need to clean up messes and waste like that. After our cleaning process is completed, we start the foil coating process by opening the adhesive foil's backing paper about 10cm from the beginning. Afterwards, we place it flat on the area we will cover. if our placement is not flat, we lift our foil and place it back flat. There will be no problem during this removal and re-sticking process. Our goal here is to put our foil in place properly. It is a very important point for the coating process we will do afterwards. Because how we start the coating process is how we will continue. After our foil fixing process is completed, we continue the foil coating process by gradually peeling off the oily paper on the back of our adhesive foil, while using a felt rag or hand puller to help with right and left movements. One of the most important points here is that we keep our foil taut and parallel to the surface we are covering. The more we keep our adhesive foil taut, the smoother and easier our foil application process will be. While our foil coating process is ongoing, some parts may have bubbles (air bubbles) on the surface. this is acceptable during the coating process and its solution is quite simple. With the help of a pin, we puncture this bubble (air bubble) in a tiny way and gently press to remove the air inside. We repeat this process for all the bubbles left on the surface. When applying foil, it's important to take your time and work slowly, rather than rushing through the process. When we process quickly, we can get wrinkles and a lot of bubbles (air bubbles) on the surfaces we cover. Therefore, we can cover our foil by slowly unfolding our oil paper and using a rag to make horizontal movements. If there are edges we need to turn, we can smoothly turn and pass over them with the help of our palms. In these corner turns, we can usually achieve better results with hand assistance and palm, rather than with a ragle. After the application process is completed, do not forget to apply transparent silicone to the edges. Bathroom etc. Since the places will be wet and damp, preventing water from entering from the edges will further extend its lifespan. The product is not affected by water and humidity except for its edges. Since it is a coating, you need to be careful when pulling heavy items on it. using felt chair protectors on the legs of items such as chairs will extend the life of the product.