Free shipping
Choice 0g-5kg Load Cell Resistive Membrane Pressure Sensor Module Flexible Force Sensitive Analog FSR402 4m
No reviews yet.
Checkout Discount 20% Off
At checkout
22.86 SAR
28.57 SAR
Free shipping
Delivery address
Estimated delivery: 2 - 7 December
Select your address, find out the delivery date!
Trendyol's commitments
Easy and free return in 15 days.
Payment methods
Highlighted features:
Choice3 0g-5kg Load Cell Resistive Membrane Pressure Sensor Module Flexible Force Sensitive Analog FSR402 4m features
Instructions for Use/Warnings
*0g-5kg
Big Save Store
8.8
80.6K followers
Seller information
Choice3 0g-5kg Load Cell Resistive Membrane Pressure Sensor Module Flexible Force Sensitive Analog FSR402 4m reviews
No reviews yet.
Product details

Additional info
- A maximum of 10 units of this product can be ordered. Trendyol reserves the right to cancel orders over 10 units.
- Barcode No: 3605326740027
Choice3 0g-5kg Load Cell Resistive Membrane Pressure Sensor Module Flexible Force Sensitive Analog FSR402 4m features
Instructions for Use/Warnings
*0g-5kg
Safety information
Product safety information
Product description
Color:0g-5kg
Pin Description:
VCC: positive supply voltage (5V)
GND: negative supply voltage
DO: High point level signal output
AO: analog voltage signal output (0-3.3V)
AO-RES: magnification adjustment potentiometer
DO-RES: comparison threshold adjustment potentiometer
Instructions for use:
Gasket installation
Place the green surface of the gasket on the sensor, in the center of the sensor sensing area, and then apply the tested object vertically to the gasket, so that the effective contact and force of the sensor and the tested object all act on the sensor sensing area.
Precautions when installing and using the sensor
1. Try to choose a stable, smooth and flat installation surface;
When your mounting surface is curved, you must bend it when you install the sensor, so that-the sensor sensing area will be stressed, which will affect the accuracy of the sensor to a certain extent, so be careful not to make the sensor effective The surface is installed on a curved surface with a large curvature (Note: the round effective surface cannot be bent, and the long tail can be bent);
2. It is recommended to use a flexible gasket with a relatively stable elasticity between the sensor and the measured object to ensure effective contact between the sensor and the measured object;
3. Keep the contact surface of the sensing area clean;
4. The force should not exceed its rated range;
5. Try not to solder it directly to the universal board or the circuit board without the specific package belonging to it, so as to avoid the thermal deformation of the tail and poor contact. The metal terminal of the sensor can be connected to the wire by fast welding.



