Choice 1 switch 2 remote Wireless RF 433Mhz Light Switch Module DC 12V 1CH 10A Relay Receiver ON OFF Remote

Please Note:

The system can store for 25 pcs of remotes , if the remote get more than 25 pcs , the initial remote control will be lost .

Specifications:

Receiver(switch)
Input voltage: DC 12V
Working current: 10A
Maximum load power: 110W
Frequency: 433Mhz
Support encoding format: EV1527
Wiring method: NC COM NO
Working mode: Momentary, Toggle, Latching Time delay (5s ,10s ,15s )

Remote Controller:
Operating RF Frequency: 433MHz.
Coded System: 1527 Learning Code.
Working Voltage: DC 3V.
Working Current: <25mA
Transmitting Power: 10mW.
Wireless Operating Distance: 50m(Free Space).
Transmission Rate: 50 ~ 60KHz.
Frequency Deviation: +0.2MHz or -0.2MHz.
Color: Black.

About Working Mode:

Momentary: Press the remote button, the relay connects, release the remote button, the relay disconnects.
Toggle: Press once the remote button, the relay connects, press the remote button twice, the relay disconnects.
Latching: Press the remote button A, the relay connects, press the remote button B, the relay disconnect.
Time Delay Mode: Press the remote control button, the relay connects; Start timing when release the remote button, the relay disconnect automatically after 5s or 10s or 15s

How To Use:

1.Momentary mode

Press the learning key of the receiver once;and then press the A/ON button of the remote;The indicator light flash, indicating that the learning is successful;Press the button, the light will turn on; release the button, the light will turn off

2.Toggle mode (self-locking)

Press the learning key of the receiver twice;and then press the A/ON button of the remote;Toggle (self-locking) mode learning is complete

3.Latched mode (internlock)

Press the learning key of the receiver three times;press the A/ON button of the remote and then press the B/OFF button;Button A/ON turn on the light, and the button B/OFF turn off the light

4.Delay function

Press the learning key of the receiver four times;and then press the A/ON button of the remote;The light will automatically turn off after 5 seconds;If you need a longer delay, you can press the learning key a few more times during pairing, and each additional press will delay for 5 seconds

5.Clearing code

Keep press the learning key of the receiver;The indicator light flashes, indicating that the clearing code is successful