Free shipping
Generic DRV8833 Motor Driver Module 1.5A Dual H Bridge DC Gear Motor Driver Controller Board for 3D Printer
-20%
(incl. VAT)
Trendyol's commitments
Easy and free return in 15 days.
Highlighted features:
Available campaigns
Applied at checkout
Seller information
Generic DRV8833 Motor Driver Module 1.5A Dual H Bridge DC Gear Motor Driver Controller Board for 3D Printer reviews
Product details

Product description
Product description Features: Motor control modes: clockwise (CW), counterclockwise (CCW), short pause and stop.
Built-in thermal shutdown circuit and low voltage detection circuit.
All DRV8833 pins split into 2.54mm pitch pins and can be plugged into the breadboard.
Filter capacitors on both supply lines.
Ideal for DIY and smart car projects.
ULT PIN: The low level is the standby mode (you need to disconnect the short J2 solder connection behind the module).
OUT1, OUT2: IN1/IN2 controlled 1-channel H-bridge.
OUT3, OUT4: 2-channel H-bridge controlled by IN3/IN4. EEP PIN: Output protection.
No need to connect by default.
VDC:3-10V GND is the earth.
Parameters: 1. Driver Chip: DRV8833 2. Size: 18.5 x 16 mm/0.73 x 0.63 inches.
3. Input Voltage: 3V-10V 4. Single H-bridge output current: 1.5A (can drive two DC motors) 5. Built-in over-current protection, short circuit protection, undervoltage lock and overheat protection.
6. With power saving mode.
7. With low power standby mode.
Application: 1. DC motor whose drive current is less than 1.5A.
2. 4 wire stepper motor Package includes: 2 x DRV8833 Motor Control Module
Additional info
- A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
- Sold by .
- Barcode No: CofLt8gTPfBC7cSAYhuFKql1Fy6ELTrkevSBG








