Generic - L293D Motor Driver Stepper Servo Shield for Arduino

Product description

L293D is a monolithic integrated, high voltage, high current, 4-channel driver.

Basically this means using this chip you can use DC motors and power supplies of up to 36 Volts, that's some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what's known as a type of H-Bridge.

The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.

g.

motor.

This L293D Motor Driver/Servo Shield for Arduino is probably one of the most versatile on the market and features 2 servo and 4 motor connectors for DC or stepper motors.

That makes it a great shield for any robotic project.

This Arduino compatible motor Driver shield is a full-featured product that it can be used to drive 4 DC motor or two 4-wire steppers and two 5v servos.

It drives the DC motor and stepper with the L293D, and it drives the servo with Arduino pin9 and pin10. L293D is a monolithic integrated, high voltage, high current, 4-channel driver.

Basically, this means using this chip you can use DC motors and power supplies of up to 36 Volts, that some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what’s known as a type of H-Bridge.

The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.

g.

a motor.

The shield contains two L293D motor drivers and one 74HC595 shift register.

The shift register expands 3 pins of the Arduino to 8 pins to control the direction of the motor drivers.

Additional info

• Sold by
  QFASFF
  .
• A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
• Barcode No: TY3_35fBQKJAiYmtXBmaMXyBSR9uk1g_5Pj1yHq0