Generic VFD Inverter Single Phase to 3 Phase, 400W 220V Output

Product description

Spec: Item Type: Variable Frequency Drive Controller Material: PC Flame Retardant Model: UX 52 100 400W Input: 176-264V 50 or 60HZ Output: 0-220V 400W 2A Frequency Range: 0.1-400HZ How to Use: After connecting to the circuit, adjust the knob buttons can be used.

PackageList: 1 x Variable Frequency Drive Controller 1 x Manual Note1.The side of the machine body is covered with heat dissipation holes.

When installing, a gap of no less than 2cm must be reserved on the left, right and back.

It is not allowed to be sealed and installed in a small and unventilated case.

Do not stack other heat-generating devices to avoid blocking the heat dissipation air ducts.

High temperatures can trigger overheat protection and shorten the lifespan.2. The working environment should be far away from water sources, water mist, dust and oil mist.

Do not use outdoors, in damp basements, or in areas where machine tool cutting fluids splash.

Avoid prolonged direct sunlight.3. This machine is rated at 400W and can only drive three-phase 220V asynchronous motors with a power of no more than 400W.

It is strictly prohibited to drive motors that exceed the power limit, are missing phases, have damaged windings, or are stuck or blocked, as this can easily trigger overcurrent and cause the machine to explode.4. The recommended frequency for long-term operation is 10 to 50Hz.

When the motor operates at a low speed below 5Hz for a long time, it will heat up.

The load needs to be reduced.

Additional info

• Sold by
  MGM
  .
• A maximum of 5 units of this product can be ordered. Trendyol reserves the right to cancel orders over 5 units.
• Barcode No: CofLt8gTPfBC7cE1t6HzWXz9N1BwDn3cp0meo